The DAP Qi-4200 is a 4x 200 watt amplifier suitable for the DAP-Xi speaker series. Each channel has its own gain control and protect, limit and signal indicator LEDs. This amplifier is not only suitable for DAP Xi speakers but can also be applied for mobile use due to its rugged steel housing.
The Qi-4200 has 4 routable XLR inputs and speakON outputs. They can be set in either bridge and stereo mode. Equipped with SMPS and Class D amplification, it is a lightweight and energy efficient solution delivering a high quality sound signal.
This device is save to use thanks to its advanced protection circuit. It is protected from overload, overheat and clipping due to various built-in protection mechanisms, such as a softstart and clip limiter. Furthermore, the Qi-series is made with high-quality low-deviation components to ensure a long lifespan and a perfect sound quality.
Output per channel into 8 ohms at 1 kHz
120 W
Output per channel into 4 ohm at 1 kHz
200 W
Bridge Output into 8 ohms at 1 kHz
400 W
Output per channel into 8 ohm at 20 Hz > 20 kHz
120 W
Output per channel into 4 ohm at 20 Hz > 20 kHz
200 W
Bridge Output 8 ohm on 20 Hz > 20 kHz
400 W
Output Mode
4-channel, Bridge, Stereo
Output Connector
Speaker Connector 4 pole
Mono Input Connector
3-pin XLR
Mono Balanced Input Maximum Level
20 dBu
Mono Input Impedance
20 Ω
Mono Unbalanced Input Sensitivity
1 dBv
Signal-to-noise Ratio
> 90 dB
Frequency Response Minimum
10 Hz
Frequency Response Maximum
20 Hz
Power Supply
100-240 VAC 50-60 Hz
Power Connector in
IEC
Amplifier Airflow
Front to back
Amplifier Cooling
Axial fan
Installation Depth (excl. connector)
390 mm
IP Rating
IP20 (indoor use only)
Electronic Protection
Clip limiter (fixed), DC voltage, RF, Short circuit, Softstart, Thermal
LED Indicators
Clip, Power, Protect, Signal
Included Cables
IEC cable
Included Accessories
Rubber feet, User Manual